Media Wall Builders
Electric Fire Installation
Inset and wall-mounted electric fires fitted into media walls with correct clearances, ventilation and a dedicated fused supply.

What's involved
Most media walls use a letterbox inset electric fire, typically 1000 to 1800 mm wide. Each model has a specified cut-out size and, for many, a ventilation gap or heat-resistant zone above it. The TV should sit far enough above the fire that warm air from the heater does not blow onto the screen, often 300 mm or more. The fitter frames the box to the exact size, lines it with plasterboard and leaves access to the fire's fused spur. Fires with heaters typically draw up to 2 kW, so a fused connection unit is fitted within reach. Install takes half a day once the frame is ready. You need to choose a fire before framing begins, because changing models later usually means rebuilding the opening.
How we handle it
Send us your plan
Use the quote form to share the wall width and height, TV size, fire model if chosen and any feature ideas. Photos of the room and wall help us match you with the right fitter.
Design and price
A local fitter visits to measure, check the existing wall and power, and agree the TV height, fire position and niche layout. You receive a fixed written price.
Frame and first fix
The stud frame goes up with noggins where needed, and the electrician runs cables, conduit and back boxes before any boards are fitted.
Board and finish
Plasterboard is fixed, joints are taped and filled or the wall is skimmed. Fire and LED channels are installed and the wall is left to dry ready for painting.
Fit, test and hand over
Sockets go on, the fire and lights are connected and tested, the TV is mounted if supplied, and you receive the electrical certificate and a tidy room.
Price guide
Media wall prices depend on the width and height of the wall, the number of niches, the finish and how much electrical work is needed. The fire and TV are usually bought separately, though fitters can supply fires. Every quote is fixed after a site visit and states clearly what is and is not included.
- Slatted panel or cladding finish: from £350. Acoustic oak slats or stone-effect panels on part of the wall, depending on area.
- Sockets, conduit and cabling: £250–£600. Behind-TV sockets, HDMI conduit and equipment cupboard power, tested and certified.
- Electric fire supply and fit: £450–£1,500. Inset letterbox fire from 1000 to 1800 mm, fitted and connected to a fused spur.
Questions about electric fire installation
Is it safe to put a TV above an electric fire?
Yes, if the fire is designed for it and the manufacturer's clearances are followed. Many electric fires blow warm air forward or down, but some vent upwards. Leave the recommended gap, often 300 mm or more, and avoid placing the TV directly in the heater's airflow. The flame effect alone gives off very little heat.
Other services
Full Media Wall Builds
Floor-to-ceiling media walls with TV recess, electric fire inset, side niches and hidden cables, finished ready for decorating.
TV Recess and Mounting
Recessing the TV flush into the wall or mounting it on a heavy-duty bracket, with noggins and back boxes for power and HDMI.
Cable Management and Electrics
Sockets, conduit, HDMI runs and LED drivers installed so all cables are hidden and can be replaced later without opening the wall.
LED Lighting and Feature Finishes
Recessed LED channels, backlit niches, slatted timber panels, stone-effect cladding and other finishes that make the wall stand out.
Media Wall Alterations and Removals
Resizing TV recesses for a new screen, swapping fires, repairing cracks or removing an old media wall and making good.
Electric Fire Installation near you
Get a free media wall builders quote
Tell us what you need and we'll come back with a clear price.
Request a quote